Macsense Connectivity MPC-200 Manuel d'utilisateur

1User’s Manual Fast Ethernet CardBus(MPC-200)Racsense

¥ Drag the FastEther Card icon that appears on the desktop to the Trash. ¥ Then the FastEther Card will eject automatically.Chapter 3 Driver Installat

Appendix A Specifications¥ Network standard: 10Mbps IEEE 802.3 10BASE-T Ethernet100Mbps IEEE 802.3u 100BASE-TX Fast Ethernet¥ Type II PCMCIA, Hot Plug

Appendix B Pin AssignmentRJ-45 connectorThe RJ-45 connector is used to connect with a hub or switch, RJ-45 regular ports canbe attached to any devices

CopyrightCopyright © 1998 by this company. All right reserved. No part of this documentationmay be reproduced in any form or by any means or used to m

Table of ContentsChapter 1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1Features . . . . . . . . . . . . .

Chapter 1 IntroductionThis manual describes how to operate the Fast Ethernet CardBus Card. The FastEthernet LAN PC Card is a Credit-card sized Etherne

¥ Bus Width: 32 bits¥ Power: 3.3 V¥ Temperature: 0ûC~60ûC/ 32ûF~140ûF (Std. Operating)¥ Humidity: 10% to 90%¥ Distance: 100m from Hub to Node¥ Dimensi

Chapter 2 Getting StartedInstalling the Fast Ethernet CardBus CardYou will be installing the Fast Ethernet CardBus Card in CardBus slot of your comput

LED Indicators¥ 100 LED: This LED is used to indicate the Ethernet speed: The green lightindicates a connection with a 100BASE-TX Fast Ethernet netwo

Chapter 3 Driver Installation for Mac OSSystem Requirements ¥ Mac OS version 8.1 or above.¥ Macintosh G3 PowerBook Series.¥ Card and Socket Service 3.

4. Click the Install button. The Installer will install the appropriate driver to your com-puter.5. Click the Restart button when installation is comp

¥ Close the control panel when you have finished.¥ To confirm the change of network connections, click OK.TCP/IP Setup¥ Open the TCP/IP control panel.